Comdial DXP, DXP Plus, FX Attendant Manual page 101

GCA70250
• To transfer a call over an E & M tie line,
1. ANSWER the incoming call.
2. SELECT CONF.
3. DIAL the E & M access code that was assigned by the installer, OR IF
your system has been configured by the installer to use Automatic
Route Selection (ARS), DIAL the ARS access code (9 by default).
4. WAIT until you hear a dial tone, THEN DIAL the intercom number
for the distant party to whom you are transferring the call.
5. WAIT on the line until the called party answers so that you can
announce the call (screened transfer), OR HANG UP (unscreened
transfer). You have created an unattended conference and your station
appears as if on hold.
6. PRESS TAP button to rejoin the transferred call.
7. After rejoining the conference, PRESS # to place the call on hold
again (creating another unattended conference) OR HANG UP to ter-
minate the call.
If one of the parties does not hang up or you have not terminated the
call, the call will return to you when the line-to-line connection timer
expires.
• To set up a conference call on an E & M tie line,
1. MAKE first call.
2. SELECT CONF; call is placed on hold automatically.
3. SELECT next line AND MAKE next call.
4. SELECT CONF to establish conference.
5. Press TRNS/CNF button to add more parties for up to a seven party
conference (including yourself).
• To continue conversation on remaining line after other
outside lines have dropped out of conference,
—PRESS the line button of the remaining party.
• To retrieve a line from hold and bring that party back into
the conference,
1. PRESS TRNS/CNF.
August, 03 Comdial
Attendant Manual
91