Troubleshooting Memory Faults; Using Leds To Identify The State Of Devices; Front And Rear Panel Leds; Figure - Fujitsu SPARC Enterprise T2000 Service Manual

Fujitsu server user manual
Hide thumbs Also See for SPARC Enterprise T2000:
Table of Contents

Advertisement

3.1.1.3

Troubleshooting Memory Faults

If you suspect that the server has a memory problem, follow the flowchart (see

FIGURE 3-1

command lists memory faults and lists the specific DIMMS that are associated with
the fault. Once you identify which DIMMs you want to replace, see
"Removing DIMMs" on page 5-12
It is important that you perform the instructions in that chapter to clear the faults
and enable the replaced DIMMs.
3.2
Using LEDs to Identify the State of
Devices
The server provides the following groups of LEDs:
Section 3.2.1, "Front and Rear Panel LEDs" on page 3-8
Section 3.2.2, "Hard Drive LEDs" on page 3-11
Section 3.2.3, "Power Supply LEDs" on page 3-12
Section 3.2.4, "Fan LEDs" on page 3-13
Section 3.2.5, "Blower Unit LED" on page 3-13
Section 3.2.6, "Ethernet Port LEDs" on page 3-14
These LEDs provide a quick visual check of the state of the system.
3.2.1

Front and Rear Panel LEDs

The six front panel LEDs (
server chassis. Three of these LEDs are also provided on the rear panel (
3-8
SPARC Enterprise T2000 Server Service Manual • April 2007
). Run the ALOM CMT showfaults command. The showfaults
FIGURE 3-2
for DIMM removal and replacement instructions.
) are located in the upper left corner of the
Section 5.2.3,
).
FIGURE 3-3

Advertisement

Table of Contents
loading

Table of Contents