Fujitsu SPARC Enterprise T2000 Service Manual page 169

feature specifications, 2-4
features, server, 2-2
field-replaceable units (FRUs) also see FRUs, 5-1
FIOBD (front I/O board FRU name), A-5
firmware, 2-5
flexible cable, 5-19, 5-24
fmadm command, 3-44, 5-16
fmdump command, 3-42
front bezel
removing, 5-8
replacing, 5-42
front I/O board, A-5
removing, 5-35
replacing, 5-36
front panel
illustration, 2-9
LED status, displaying, 3-22
LEDs, 3-8
FRU ID PROMs, 3-16
FRU replacement, common procedures, 5-1
FRU status, displaying, 3-25
FRUs
hot-swapping, 4-1
illustration of, A-2
names, locations, and descriptions, A-4
replacing, 5-8
FT0 (fan FRU names), A-5
FT2 (rear blower FRU name), A-5
H
hard drive controller, 6-1
hard drives, A-6
adding additional, 6-1
hot-plugging, 4-9
identification, 4-9
latch release button, 4-10
LEDs, 3-11
removing, 4-9
replacing, 4-9, 4-10
slot assignments, 6-3
specifications, 2-4
status, displaying, 3-22
hardware components sanity check, 3-31
HDD (hard drive FRU names), A-6
help command, 3-19
host ID, 5-18
hot-pluggable devices, adding, 6-1
hot-plugging hard drives, 4-9
hot-swappable devices
fans, 4-2
FRUs, 4-1
overview, 2-6
power supplies, 4-4
I
I/O board see also motherboard, 5-19
identification of chassis, 2-9
indicators, 3-8
installing additional devices, 6-1
insulating washer for motherboard, 5-26
interlock, 5-1
intrusion switch, 5-1, 5-41
IOBD (motherboard FRU name), A-4
J
JBus I/O interface, 2-3
L
L1 and L2 cache, 2-3
large page optimization, 2-3
latch release button, hard drive, 4-10
LED board, A-5
removing, 5-32
replacing, 5-33
LEDBD (LED board FRU name), A-5
LEDs
about, 3-8
AC OK, 3-4, 3-12
blower unit fault, 3-13
Ethernet port, 3-14
fan, 4-2
fan fault, 3-13
front panel, 3-8
hard drive, 3-11
hard drive activity, 3-11
Locator, 3-10
OK to Remove, 3-11
Overtemp, 3-11, 4-2
Power OK, 3-4, 3-10
power supply, 3-12
Rear Blower Fault, 4-8
Rear FRU fault, 3-10
Index-3