Fujitsu SPARC Enterprise T2000 Service Manual page 121

6. Gain access to the ALOM CMT sc> prompt.
Refer to the SPARC Enterprise T2000 Advanced Lights Out Management (ALOM) Guide
for instructions.
7. Run the showfaults -v command to determine how to clear the fault.
The method you use to clear a fault depends on how the fault is identified by the
showfaults command.
Examples:
If the fault is a host-detected fault (displays a UUID), continue to
■
example:
sc> showfaults -v
ID Time
0 SEP 09 11:09:26
MSGID:
SUN4V-8000-DX UUID: 7ee0e46b-ea64-6565-e684-e996963f7b86
If the fault resulted in the FRU being disabled, such as the following,
■
sc> showfaults -v
ID Time
1 OCT 13 12:47:27
deemed faulty and disabled
Then run the enablecomponent command to enable the FRU:
sc> enablecomponent MB/CMP0/CH0/R0/D0
8. Perform the following steps to verify the repair:
a. Set the virtual keyswitch to diag so that POST will run in Service mode.
sc> setkeyswitch diag
b. Issue the poweron command.
sc> poweron
FRU
MB/CMP0/CH0/R0/D0 Host detected fault,
FRU
MB/CMP0/CH0/R0/D0 MB/CMP0/CH0/R0/D0
Chapter 5 Replacing Cold-Swappable FRUs
Step 8. For
Fault
Fault
5-15