Replacing Dimms - Fujitsu SPARC Enterprise T2000 Service Manual

TABLE 5-1
DIMM Name Used in Messages
CH1/R1/D0
CH1/R0/D0
CH2/R1/D1
CH2/R0/D1
CH2/R1/D0
CH2/R0/D0
CH3/R1/D1
CH3/R0/D1
CH3/R1/D0
CH3/R0/D0
* DIMM names in messages are displayed with the full name
such as MB/CMP0/CH1/R1/D1. This table omits the preced-
ing MB/CMP0 for clarity.
3. Note the DIMM locations so you can install the replacement DIMMs in the same
sockets.
4. Push down on the ejector levers on each side of the DIMM connector until the
DIMM is released.
5. Grasp the top corners of the faulty DIMM and remove it from the system.
6. Place DIMMs on an antistatic mat.
5.2.4

Replacing DIMMs

1. Unpackage the replacement DIMMs and place them on an antistatic mat.
2. Ensure that the connector ejector tabs are in the open position.
3. Line up the replacement DIMM with the connector.
Align the DIMM notch with the key in the connector. This action ensures that the
DIMM is oriented correctly.
4. Push the DIMM into the connector until the ejector tabs lock the DIMM in place.
5. Perform the procedures described in
Finishing Up" on page
5-14 SPARC Enterprise T2000 Server Service Manual • April 2007
DIMM Names and Socket Numbers (Continued)
*
5-41.
Socket No.
J1301
J1101
J1901
J1701
J1801
J1601
J2401
J2201
J2301
J2101
Section 5.3, "Common Procedures for