Fujitsu SPARC Enterprise T2000 Service Manual page 14

Replacing the Blower Unit 4-8
FIGURE 4-5
Locating the Hard Drive Release Button and Latch 4-10
FIGURE 4-6
Slide Release Latches 5-4
FIGURE 5-1
Locating the Metal Lever 5-5
FIGURE 5-2
Top Cover and Release Button 5-7
FIGURE 5-3
Removing the Front Bezel From the Server Chassis 5-8
FIGURE 5-4
Location of PCI-Express and PCI-X Card Slots 5-9
FIGURE 5-5
Location of PCI-Express and PCI-X Card Slots 5-10
FIGURE 5-6
PCI Card and Hold-Down Bracket 5-11
FIGURE 5-7
DIMM Locations 5-13
FIGURE 5-8
Ejecting and Removing the System Controller Card 5-18
FIGURE 5-9
Locating the System Configuration PROM 5-18
FIGURE 5-10
Motherboard Assembly 5-20
FIGURE 5-11
Cable Cutout 5-21
FIGURE 5-12
Location of the Screws in the Motherboard Assembly 5-22
FIGURE 5-13
Removing the Motherboard Assembly From the Server Chassis. 5-23
FIGURE 5-14
Installing the Motherboard Assembly 5-25
FIGURE 5-15
Securing the Motherboard Assembly to the Chassis 5-26
FIGURE 5-16
Location of Power Supply Latch 5-28
FIGURE 5-17
Location of Bus Bar Screws on the Power Distribution Board and the Motherboard
FIGURE 5-18
Assembly 5-29
Removing the Power Distribution Board 5-30
FIGURE 5-19
Installing the Power Distribution Board 5-31
FIGURE 5-20
Removing the LED Board From the Chassis 5-33
FIGURE 5-21
Removing the Fan Power Board 5-34
FIGURE 5-22
Removing the Fan Guard 5-35
FIGURE 5-23
Removing the Front I/O Board 5-36
FIGURE 5-24
Removing the SAS Disk Backplane 5-38
FIGURE 5-25
Replacing the SAS Disk Backplane 5-39
FIGURE 5-26
Removing the Battery From the System Controller 5-40
FIGURE 5-27
xii SPARC Enterprise T2000 Server Service Manual • April 2007