Replacing A Hard Drive; Figure 4-6 Locating The Hard Drive Release Button And Latch - Fujitsu SPARC Enterprise T2000 Service Manual

FIGURE 4-6
2. Issue the Solaris OS commands required to stop using the hard drive.
Exact commands required depend on the configuration of your hard drives. You
might need to unmount file systems or perform RAID commands.
3. On the drive you plan to remove, push the latch release button (
The latch opens.
Caution – The latch is not an ejector. Do not bend it too far to the left. Doing so can
damage the latch.
4. Grasp the latch and pull the drive out of the drive slot.
4.5.2

Replacing a Hard Drive

1. Align the replacement drive to the drive slot.
The hard drive is physically addressed according to the slot in which it is installed.
See
FIGURE 4-6
which the drive was removed.
4-10 SPARC Enterprise T2000 Server Service Manual • April 2007
Latch release
Latch
button
Locating the Hard Drive Release Button and Latch
. It is important to install a replacement drive in the same slot from
HDD2
HDD0
HDD3
HDD1
).
FIGURE 4-6