Removing The Front I/O Board; Figure 5-23 Removing The Fan Guard - Fujitsu SPARC Enterprise T2000 Service Manual

2. Lower the board into place and slide the board to the left to plug it into the front
I/O board.
3. Secure the board to the chassis with the screws.
4. Reinstall all three fans.
See Section 4.2.2, "Replacing a Fan" on page
5. Perform the procedures described in
Finishing Up" on page
5.2.15

Removing the Front I/O Board

1. Perform the procedures described in
Replacement" on page
2. Remove all three fans.
See Section 4.2.1, "Removing a Fan" on page
3. Disengage the fan power board from the front I/O board
Step 3
4. Remove the fan guard to gain access to the M3x6 flat-head screw that secures the
front I/O board to the chassis.
a. Remove the screw that secures the fan guard to the chassis.
FIGURE 5-23
b. Remove the fan guard from the chassis.
5. Disconnect the front I/O board data cable.
5-41.
5-1.
and Step 4 in Section 5.2.13, "Removing the Fan Power Board" on page
Removing the Fan Guard
4-4.
Section 5.3, "Common Procedures for
Section 5.1, "Common Procedures for Parts
4-2.
Fan guard
Chapter 5 Replacing Cold-Swappable FRUs
5-34.
5-35