Removing The Motherboard Assembly - Fujitsu SPARC Enterprise T2000 Service Manual

4. Ensure that the ejector levers are open.
5. Holding the bottom edge of the system controller parallel to its socket, carefully
align the system controller so that each of its contacts is centered on a socket pin.
Ensure that the system controller is correctly oriented. A notch along the bottom of
the system controller corresponds to a tab on the socket.
6. Push firmly and evenly on both ends of the system controller until it is firmly
seated in the socket.
You hear a click when the ejector levers lock into place.
7. Perform the procedures described in
Finishing Up" on page
5.2.7

Removing the Motherboard Assembly

The motherboard for your server has two distinct boards for the CPU and the I/O
board. However, they must be removed and replaced as a single motherboard
assembly (
Caution – Remove and replace the motherboard carefully. The motherboard rests
on metal standoffs. If the motherboard is not handled carefully, the components
mounted on the underside of the motherboard can be damaged if they hit the
standoffs. To ensure that this damage does not occur, perform the removal and
replacement instructions described in this document.
Caution – A flexible cable connects the CPU and I/O boards. This flexible cable is
fragile. Handle these parts very carefully to prevent damage.
Caution – This procedure requires that you handle components that are sensitive to
static discharges that can cause the component to fail. To avoid this problem, ensure
that you follow antistatic practices as described in
Electrostatic Discharge Prevention Measures" on page
5-41.
).
FIGURE 5-11
Section 5.3, "Common Procedures for
Section 5.1.6, "Performing
5-6.
Chapter 5 Replacing Cold-Swappable FRUs 5-19