Replacing The Front I/O Board; Figure 5-24 Removing The Front I/O Board - Fujitsu SPARC Enterprise T2000 Service Manual

6. Remove the LED board. See
page
7. Remove the screw that secures the front I/O board to the chassis.
8. Slide the front I/O board back, tilt it up, clear the two mounting tabs in the front,
and lift the board straight out of the chassis (
FIGURE 5-24
9. Place the front I/O board on an antistatic mat.
5.2.16

Replacing the Front I/O Board

1. Unpackage the front I/O board and place it on an antistatic mat.
2. Tip the front I/O board downwards and slightly forward, and push it into place,
aligning the board with the screw hole in the exterior wall of the chassis.
When the board is fully seated, both connectors on the USB ports are mounted flush
against the motherboard assembly.
3. Using the screw, secure the front I/O board to the chassis.
4. Reconnect the front I/O board data cable.
5. Reinstall the LED board.
See Section 5.2.12, "Replacing the LED Board" on page
5-36 SPARC Enterprise T2000 Server Service Manual • April 2007
5-32.
Removing the Front I/O Board
Section 5.2.11, "Removing the LED Board" on
FIGURE 5-24
).
5-33.