Removing The Server From A Rack; Figure 5-1 Slide Release Latches - Fujitsu SPARC Enterprise T2000 Service Manual

FIGURE 5-1
4. While pinching the release latches, slowly pull the server forward until the slide
rails latch.
5.1.4

Removing the Server From a Rack

Remove the server from the rack for all cold-swappable FRU replacement
procedures except the DIMMs, PCI cards, and the system controller.
Caution – The server weighs approximately 40 lb. (18 kg). Two people are required
to dismount and carry the chassis.
1. Disconnect all the cables and power cords from the server.
2. Extend the server to the maintenance position as described in
"Extending the Server to the Maintenance Position" on page
3. Press the metal lever (
disconnect the CMA from the rail assembly (on the right side from the back of the
rack).
This action leaves the CMA still attached to the cabinet, but the server chassis is now
disconnected from the CMA.
5-4 SPARC Enterprise T2000 Server Service Manual • April 2007
Slide Release Latches
FIGURE 5-2
) that is located on the inner side of the rail to
Section 5.1.3,
5-3.