Creating Playlists; Registering Events In A Playlist - Panasonic AJ-HPM200 Operating Instructions Manual

Registering Events in a Playlist

To register an event in a playlist, either set IN and OUT points
using the player and the recorder, or select clips from the
player thumbnails.
Setting IN and OUT points to assign an
event
Defining any three of four points (the IN and OUT points of
both the player and the recorder) automatically defines the
remaining point.
It is also possible to set only the IN points for the player and
the recorder.
◆ NOTE:
• When only the IN points for the player and the recorder are set and
the player is a P2 card or hard disk, the audio and video of the event
from the IN point of the player until the end of the clip where the IN
point is set is inserted at or starts overwriting data from the recorder
IN point.
• When an external device is used as the player, audio and video up
to 24 hours (excluding the preview time) is inserted at or starts
overwriting data at the IN point of the recorder.
Selecting player
Select a P2 card, hard disk or external device (RS-422A) as a
player.
A P2 card is normally used as a player. Use the steps below
to select other devices as a player or to again select a P2 card
as a player.
OFF
METER
FULL/FINE
MONITOR
SELECT
METER SELECT
CH 1-4 CH 5-8
INPUT SELECT
VIDEO AUDIO
CH 1 CH 2 CH 3 CH 4
REC
VAR
UNITY
1
THUMBNAIL PLAYLIST VIDEO A1
EDIT MODE A3
TRIM
SET LAST X
3
SLOT SELECT
MULTI DELETE
SEL IN ENTRY
EXIT MENU
CANCEL/PF DIAG
SLOT CLIP
CLIP LIST
OPERATION
PF1

Creating Playlists

2
PREVIEW
REC A.LEVEL REC
PLAYER STOP
SOURCE SELECT STILL/
PLAY PAUSE REW FF
COUNTER
RESET
REVIEW
PREV NEXT
1 CLIP PLAY
NEW
TC PRESET
PROP
TEXT INT
TCG
MEMO
REGEN
PRESET
EXT
MARKER
A2 GO TO
A4 A.DUB
MODE
OUT
ALL CLIP
SHIFT
PF2 PF3
PF4
1
Press the PLAY LIST button to open the playlist
screen.
2
Press the SOURCE SELECT (SHIFT + PLAYER)
button.
3
Use the cursor buttons to select an interface for the
player and press the SET button.
This determines the external device (interface) that can be
remotely operated.
➝For details on connecting and setting up external
devices, refer to "Connections" (page 112) and
"External Remote Control" (page 124).
◆ NOTE:
• Devices connected using IEEE1394 cannot be used as external
devices.
89
Editing: Creating Playlists