Table of Contents
Advertisement
• Format SD memory cards on this unit. SD memory cards formatted
on a computer or other device may delay start of recording or may
not be used in this unit.
➝ Refer to "Formatting SD Memory Cards" (page 68).
• MultiMediaCards cannot be used.
SD memory card slots and access lamps
Clips recorded on SD memory cards inserted in the SD/SDHC
memory card slot on the AJ-HPM200 can be played back as
thumbnails and video clips corded on P2 cards.
■ Access lamps
Steady orange light:
Card is available for reading and
writing.
Flashing orange light
Recognition phase to determine
(fast):
whether the card is defective or not
Flashing orange light
Card is being accessed.
(slow):
Off:
Card is not available for reading and
writing.
No card is inserted, the card has not
been formatted or a non-compatible
card has been inserted.
Write protect status, no free space
left on card
SD memory card protection
Set the write-protect switch to [LOCK] to prevent accidental
deletion of data recorded on an SD card.
Write-protect switch
Formatting SD memory cards
Use the thumbnail menu to format SD memory cards.
➝Refer to "Using SD/SDHC Memory Cards" (page 68).
You can also use the menu in the AVCHD mode for formatting
SD memory cards.
➝For how to switch to the AVCHD mode, refer to "Switching
to AVCHD mode" (page 144).
1
Switch to the AVCHD mode and press the MENU
button.
32
2
Select [CARD FUNCTIONS] – [CARD FORMAT] and
press the SET button.
Select [YES] in the screen shown below that appears. To
cancel formatting, select [NO].
3
Select [YES] in the confirmation dialog.
The SD memory card will now be formatted.
4
Press the MENU button to end processing.
• Check that no important data remains on a card before
formatting since data erased by formatting cannot be
recovered.
Removing SD memory cards
1
Check that the SD memory card access lamp is not
flashing.
2
Press the center of the SD memory card and remove
it after it bounces back by pulling it outwards.
◆ NOTE:
• Be sure to remove SD memory cards only when the access
lamp is not blinking.
Removing an SD memory card when the access lamps are
blinking could damage the SD memory card or the card slot.
AVCHD Recording and Playback: Using an Optional AVCHD Board
141
Advertisement
Table of Contents
