Table of Contents
Advertisement
Monitor display
Displayed when a voice-over recording is attempted on a P2 card or when
LACK OF REC
external device is selected for a player of the playlist and the REC button is
CAP.
pressed to start recording, while there is not enough free space on the card.
Displayed for two seconds when a shot mark is added or deleted.
MARK ON/OFF
The number of events that can be registered on the playlist has been reached.
MAX. EVENTS
NEED TO REPAIR
Displayed when an SD memory card that needs to be repaired is detected.
SD
(When an AJ-YCX250G AVCHD codec board (optional) is installed.)
Displayed for the first two seconds when the REC button is pressed to enter the
NO INPUT
EE mode and the INPUT SELECT button is set to a connector with no output
except for analog audio signals.
PL FILE NOT
Displayed when a voice-over recording is attempted on a P2 card and there is no
FOUND
playlist file.
Displayed when recording cannot continue because there is no space or
REC LIMIT SD
because a 12-hour recording has been completed.
(When an AJ-YCX250G AVCHD codec board (optional) is installed.)
Displayed when an SD memory card clip is being repaired.
REPAIRING SD
(When an AJ-YCX250G AVCHD codec board (optional) is installed.)
R-OUT NOT
Displayed when an attempt was made to use a recorder OUT point during insert
AVAILABLE
editing in playlist mode.
SLOT SEL
Displayed when the SLOT SELECT +/– button was pressed while it is not possible
INVALID
to switch P2 card recording slot.
Displayed for two seconds when a text memo is added.
TEXT MEMO
TEXT MEMO
Appears when there are already 100 text memos and no more memos can be
INVALID
added.
WRITE
Appears when a voice-over recording is attempted on a write-protected P2 card. Operation
PROTECTED
WARNING information
If "E- * * " Iights in the monitor display, hold down the SHIFT button and press the MENU button to open the DIAG-MENU and
read the warning information.
Display
No
Character code
04
UNKNOWN SIG
10
FAN STOP
11
NOT 1× 25M SIG
12
NOT 1× 50M SIG
14
NO MATCH SIG
15
NOT 1× DV SIG
16
INVALID VIDEO SIG
Description
Displayed when a signal input from the 1394 interface is not a DVCPRO or DV format
signal.
Displayed when the fan motor stops.
Displayed when a signal input from the 1394 interface is not a DVCPRO (25 Mbps) 1×
normal speed transfer signal.
Displayed when a signal input from the 1394 interface is not a DVCPRO50 (50 Mbps) 1×
normal speed transfer signal.
Displayed when signal input via the 1394 interface differs from the system format set on
this unit.
Displayed when a signal input from the 1394 interface is not a DV (25 Mbps) 1× normal
speed transfer signal.
Displayed when the compressed video data of a signal input from the 1394 interface is
irregular.
Operation
continues
Operation
continues
Operation
continues
Operation
continues
Operation
continues
Operation
continues
Operation
continues
Operation
continues
Operation
continues
Operation
continues
Operation
continues
Operation
continues
continues
Description
For Long and Trouble-Free Operation: Error Messages
Deck operation
Counter display
CANTADUB
MARK ON /
MARK OFF
Counter value
ND REP
NO INPUT
CANTADUB
LIMIT SD
REPAIR
Counter value
INVALID
TEXT MEMO
INVALID
CANTADUB
Deck operation
Recording is
disabled
Operation
continues
Recording is
disabled
Recording is
disabled
Recording is
disabled
Recording is
disabled
Recording is
disabled
197
Advertisement
Table of Contents
