Table of Contents
Advertisement
HTTP CLIENT:
Item
START PAGE URL
PROXY SERVER
PROXY SERVER URL
PROXY SERVER
PORT
Setting server service
Use the steps below to set up any of the following services. A
service that is set to ENABLE can be started up and used.
FTP server
Receives access from an FTP client and
service:
transfers files. However, it cannot write
files to P2 cards.
Samba server
Allows you to load P2 cards and hard
service:
disks externally as network drives. (But it
cannot write data to P2 cards.)
HTTP server
Allows you to view P2 card thumbnails,
service:
metadata and play back proxy data (only
when the client supports playback) using
an external browser.
◆ NOTE:
• You must switch to LAN mode to use these network services.
Recording and playback and other operations are not available in
LAN mode.
➝ Refer to "Using Server Functions" (page 136).
• A server service cannot be used to write data to a P2 card. Only an
FTP client can be used to write data to P2 cards.
Item
HOSTNAME
FTP
SAMBA
WORKGROUP
HTTP
USER LOGIN
SETTING
128
Connections: Connecting This Unit to a Network
Description
URL of page displayed when
browser starts up
Turns PROXY server on or off
Name or address of a PROXY
server
Number of port used for
PROXY
Description
Host name
(up to 31 characters)
FTP server setting
SAMBA setting
Work group
(up to 31 characters)
HTTP server setting
User settings
Setup procedure
Enter using the full keyboard.
ENABLE:
Enables PROXY server
DISABLE:
Disables PROXY server
Enter using the full keyboard
Enter using the ten keypad
1
Open the thumbnail screen.
2
Press the MENU button.
3
Use the cursor buttons to choose [NETWORK] -
[SETUP] - [SERVER] and press the SET button.
4
The server screen appears.
Current settings appear. Use the cursor buttons to select
an item and press the SET button to set it.
Setting
Enter using the full keyboard.
ENABLE:
Starts up FTP server.
DISABLE:
Does not start up FTP server.
ENABLE:
Starts up SAMBA service.
DISABLE:
Does not start up SAMBA service.
Enter using the full keyboard.
ENABLE:
Starts up HTTP server.
DISABLE:
Does not start up HTTP server.
Sets user ID and password for login user. (Opens a
separate screen.)
Factory defaults
https://eww.pavc.panasonic.co.jp/pro-av/
DISABLE
No setting
8080
Initial value
AJ-HPM200
ENABLE
ENABLE
WORKGROUP
ENABLE
Only guest is registered.
(PASSWORD : p2guest)
Advertisement
Table of Contents
