CAUTION:
Do not use extension cords or power strips.
CAUTION:
The multifunction printer should not be plugged into a UPS system.
2.
Turn on the computer and the multifunction printer.
Print and Check the System Settings Page
Print a system settings page to verify the network connection. This page also provides important information
that helps you configure for network printing.
NOTE:
Depending on the network configuration, the multifunction printer may not be provided an IP
address immediately. If the System Settings page does not show an assigned IP address, wait five
minutes and try again.
1.
Press
until >SETUP appears, and then press
2.
Press
until >Reports appears, and then press
3.
System Settings is displayed. Press
The system settings page is printed.
4.
If the IP address shows anything other than 0.0.0.0 (the factory default) or 169.254.xx.xx, the
multifunction printer has an IP address assigned and stored. Go to
Assign an IP Address
.
.
.
"Verify the IP
Settings."