Purpose:
To specify PostScript communication protocol for each interface. You can configure Adobe Protocol settings
for the wireless network. The change becomes effective after the multifunction printer is turned off and then
on again.
Values:
Used when auto-detecting the PostScript communication protocol.
Auto
Used when the communication protocol is in ASCII interface.
Standard
Used when the communication protocol is in binary format.
BCP
Used when the communication protocol supports both ASCII and binary data to switch between
TBCP*
them according to the specified control code.
Used when no special processing is required.
Binary
Parallel Settings
The Parallel Settings menu can be adjusted to configure the parallel interface.
NOTE:
Values marked by an asterisk (*) are the factory default menu settings.
ECP
Purpose:
To specify the ECP communication mode of the parallel interface. The change becomes effective after the
multifunction printer is turned off and then on again.
Values:
The ECP communication mode is enabled.
Enable*
The ECP communication mode is disabled.
Disable