on the network even when the protocol is not in use. This may slightly increase network traffic. To eliminate
unnecessary traffic, you can disable unused protocols.
1.
Press
until >SETUP appears, and then press
2.
Press
until >Admin Menu appears, and then press
3.
Press
until >Wired Net or >Wireless Net appears, and then press
4.
Press
until >Protocol appears, and then press
5.
Press
to select the desired settings, and then press
Port9100
FTP
SNMP UDP
E-Mail Alert
EWS
Configuring TCP/IP
Static Addressing: TCP/IP address is assigned manually by the system administrator.
Dynamic Addressing BOOTP/DHCP(default): TCP/IP address is assigned automatically by a DHCP or
BOOTP server on your network.
Static Addressing
To enter the TCP/IP address from your multifunction printer's operator panel, take the following steps:
1.
Press
until >SETUP appears, and then press
2.
Press
until >Admin Menu appears, and then press
3.
Press
until >Wired Net or >Wireless Net appears, and then press
4.
Press
until >TCP/IP appears, and then press
5.
Press
until >IP Address appears, and then press
An IP address consists of 4 bytes.
.
.
.
.
.
.
.
.
.
.