Before Using UX Filter
Check the following items before using the UX filter.
Before setting up the workstation, set up the printer as follows.
1. Make sure the lpd port is working or not when using the network environment. If the lpd port is not working, set
LPD to On on the operator panel. (Mandatory) See "Protocol" for more information.
When a parallel or USB port is to be used, make sure these are working. (Mandatory)
2. Set up IP address and subnet mask when the printer is used in the network environment. (Mandatory)
3. Make TBCPFilter function available if TBCPFilter function is installed on the printer. See
information.
Installing the UX Filter
Before Installation
The following are required for the installation.
Supported operating system is described in
Interface."
Disk capacity: 20 MB of free disk space required, including temporary working space for installation.
Log on as a root account to perform the operation here. If you have no root privilege, contact your system
administrator.
Output printer must be registered in the workstation before using UX filter. (HP-UX)
Use sam command for registration of output printer.
For more information, see the HP-UX related manual.
Files Added by the Installation
The following files will be added when the UX filter is installed.
Solaris
Directory
/usr/local/dellbin5100cn txt2ps2
"Page-description Language (PDL)/Emulation, Operating System, and
File name
Contents
Text conversion utility
"Adobe
Protocol" for more