Dell 5100cn Color Laser Printer User Manual page 142

Job too Large
Press Set
Disk Full
016-980
Job too Large
Press Set
PCL Request
016-720
Data Violation
Press Set
Invalid Job
016-799
Data Violation
Press Set
Ready to Print
010-421
Replace Fuser
Soon
Ready to Print
094-422
Replace Transfer
Roller Soon
Replace Drum
094-402
Imaging Drum
Replace soon
CTD Sensor Dirty
092-310
Clean
CTD Sensor
Ready to Print
193-700
non-DELL Toner
Installed
current print job.
RAM disk memory is full and
cannot continue processing the
current print job.
Error relating to PCL emulation
problems occurs.
When the configuration of the
printer on the printer driver does
not conform to the printer you are
using, this message appears.
The fuser needs to be replaced.
The transfer roller needs to be
replaced.
The imaging drum needs to be
replaced.
The printer's automatic density
control (CTD) sensor needs to be
checked soon.
The printer is in the custom toner
mode.
print job, and conduct the next print job, if any.
· Press Cancel to cancel the current print job.
· Press Menu to open the Stored Print and delete
the holding job.
· To avoid this error in the future, do the following:
· Delete unnecessary fonts, macros, and other data
in printer memory.
· Install additional printer memory.
See "Accessing Held Jobs From the Operator
· Press to clear the message, cancel the current
print job, and conduct the next print job, if any.
· Press Cancel to cancel the current print job.
· Press Menu to open the Stored Print and delete
the current job.
· To avoid this error in the future, do the following:
· Reduce the number of print pages such as splitting
the print data.
· Increase free memory space by deleting
unnecessary data in the RAM disk.
See "Accessing Held Jobs From the Operator
· Press to clear the message, cancel the current
print job, and conduct the next print job, if any.
· Press Cancel to cancel the print job.
· Press Cancel to cancel the print job.
· Make sure that the configuration of the printer on
the printer driver conforms to the printer you are
using.
Replace the fuser.
See "Replacing the Fuser and Separator
Replace the transfer roller.
See "Replacing the Transfer
Replace the imaging drum.
See "Replacing the Imaging
Check the printer's CTD sensor.
See "Cleaning the Automatic Density Control (CTD)
Sensor"
When some of the toner cartridges reach the end of
their lives, you cannot continue printing.
Panel"
Panel"
Roller".
Roller".
Drums"