Dell 5100cn Color Laser Printer User Manual page 48

Installing the Optional Tray Module and Installing
Cards
Installing the Optional Tray Module
Installing the Optional 500-Sheet Tray Module
Installing the Optional 1000-Sheet Tray Module
Installing the Optional 500-Sheet Tray Module and 1000-Sheet Tray Module
Installing a Memory Card
Installing a Multi Protocol Card
Installing the Hard Drive
Installing the Optional Tray Module
NOTE: If you are adding an optional 500-sheet tray module or 1000-sheet tray module after setting up the printer,
be sure to turn off the printer, unplug the power cable, and disconnect all cables from the back of the printer before
completing these tasks.
CAUTION: To lift the optional 1000-sheet tray module safely requires two people.
NOTICE: Place the imaging drum on a clean flat surface. Also, cover the imaging drum with something like
newspaper to keep it out of direct light.
Only one optional 500-sheet tray module and one optional 1000-sheet tray module can be installed under the
printer.
Some instructions may vary depending on the tray module configuration in your printer.
NOTE: Some tray module configurations differ from those described in this manual.
Installing the Optional 500-Sheet Tray Module
1. Turn off the printer.
2. Lift the printer and align the four guide pins of the 500-sheet tray module with the holes at the bottom of the
printer. Gently lower the printer onto the optional 500-sheet tray module.
CAUTION: To lift the printer safely, remove the imaging drum and lift it with two people. Never try to
lift the printer while facing its right and left sides.
NOTE: Be careful not to pinch your fingers when lowering the printer onto the optional 500-sheet tray module.