Intel BX80562Q6600 - Core 2 Quad 2.4 GHz Processor Specification page 55

Errata
AK100. Updating Code Page Directory Attributes without TLB Invalidation
May Result in Improper Handling of Code #PF
Code #PF (Page Fault exception) is normally handled in lower priority order
Problem:
relative to both code #DB (Debug Exception) and code Segment Limit
Violation #GP (General Protection Fault). Due to this erratum, code #PF may
be handled incorrectly, if all of the following conditions are met:
A PDE (Page Directory Entry) is modified without invalidating the corresponding
•
TLB (Translation Look-aside Buffer) entry
Code execution transitions to a different code page such that both
•
• The target linear address corresponds to the modified PDE
• The PTE (Page Table Entry) for the target linear address has an A (Accessed) bit
that is clear
• One of the following simultaneous exception conditions is present following the
code transition
• Code #DB and code #PF
Code Segment Limit Violation #GP and code #PF
•
Implication: Software may observe either incorrect processing of code #PF before code
Segment Limit Violation #GP or processing of code #PF in lieu of code #DB.
Workaround: None identified.
For the steppings affected, see the Summary Tables of Changes.
Status:
AK101. Performance Monitoring Event CPU_CLK_UNHALTED.REF May Not
Count Clock Cycles According to the Processors Operating Frequency
Performance Counter MSR_PERF_FIXED_CTR2 (MSR 30BH) that counts
Problem:
CPU_CLK_UNHALTED.REF clocks, should count these clock cycles at a
constant rate that is determined by the maximum resolved boot frequency,
as programmed by BIOS. Due to this erratum, the rate is instead set by the
maximum core-clock to bus-clock ratio of the processor, as indicated by
hardware.
Implication: No functional impact as a result of this erratum. If the maximum resolved
boot frequency as programmed by BIOS is different from the frequency
implied by the maximum core-clock to bus-clock ratio of the processor as
indicated by hardware, then the following effects may be observed:
Performance Monitoring Event CPU_CLK_UNHALTED.REF will count at a rate
•
different than the TSC (Time Stamp Counter)
When running a system with several processors that have different maximum
•
core-clock to bus-clock ratios, CPU_CLK_UNHALTED.REF monitoring events at
each processor will be counted at different rates and therefore will not be
comparable.
Workaround: Calculate the ratio of the rates at which the TSC and the
CPU_CLK_UNHALTED.REF performance monitoring event count (this can be
done by measuring simultaneously their counted value while executing code)
Intel ® Core™2 Extreme Quad-Core Processor QX6000
Intel ® Core™2 Quad Processor Q6000
Specification Update
Δ Sequence and
Δ Sequence
55