Canon imagePROGRAF iPF825 MFP M40 User Manual page 710

Printer Parts > Printer parts
d. Roll Holder
Load the roll on this holder.
e. Protective Cloth for Sheets
A cloth tray that catches ejected sheets.
f. Paper Feed Slot
When loading a roll, insert the edge of the roll paper here. You can load rolls in two positions, on the printer side in the
Roll 1 (Upper) position and on the roll unit side in the Roll 2 (Lower) position.
g. Holder Stopper
Secure rolls on the Roll Holder with this part.
h. Ink Tank Cover
Open this cover to replace an Ink Tank. (See "Ink Tank Cover (Inside).")
i. Control Panel
Use this panel to operate the printer and check the printer status. (See "Control Panel.")
j. Release Lever
Releases the Paper Retainer. Lift this lever toward the front of the printer when loading paper.
k. Maintenance Cartridge
Ink used for maintenance purposes such as head cleaning is absorbed. (Replace the cartridge when it is full.)
l. Carrying Handles
When carrying the printer, have six people hold it by these handles under both sides.
m. Maintenance Cartridge Cover
Open this cover to replace the Maintenance Cartridge.
n. Stand
9
A stand that holds the printer. Equipped with casters to facilitate moving it.
o. Stand L
The left leg of the Stand.
p. Stand R
The right leg of the Stand.
q. Leg Covers
Covers for Stand L and Stand R.
r. Stopper
Locks the Stand casters.
Always release the Stopper before moving the printer. Moving the printer while the Stopper is locked may scratch the
casters or the floor.
s. Roll Unit
694
A unit for loading two rolls.
t. Roll Unit Lever
Hold this lever to pull out the Roll Unit.
Front
>
→P.698
→P.700
iPF825