Fitting Trunk Cards (Soe) - Avaya IP Office Installation Manual

5.7 Fitting Trunk Cards (SOE)

All trunk cards are supplied with 2 plastic snap-in stand off pillars and a blanking plate appropriate to the cards ports.
The blanking plate is not required with the Small Office Edition.
Warnings
1. Correct anti-static protection steps should be taken before handling circuit boards.
2. During this process power to the IP Office control unit must be switched off and disconnected.
Parts and Equipment Required
1. o Trunk Card or Cards
Check that the correct card has been supplied.
IP400 Trunk Cards
Tools Required
1. o Cross-head screwdriver.
2. o Anti-static wrist strap and ground point.
3. o IP Office Monitor application.
IP Office Installation
IP Office
Analog Trunk Card (ATM4)
Analog Trunk Card (ATM4U)
Quad BRI Trunk Card
Single PRI T1 Trunk Cards
Single E1 PRI Trunk Cards
Single E1R2 Trunk Cards
Dual PRI Trunk Cards
WAN Port Card
SOE
15-601042 Issue 19l (06 November 2008)
Page 82