Setup Window - Steinberg MR816CSX Operation Manual

■ Setup window

This section explains the Setup window called up by clicking the SETUP icon (
this window, you can set basic parameters such as Sample Rate and Word Clock Source of the MR816 CSX/MR816 X. To
close the Setup window, press the [X] button at the top left corner.
NOTE
· The parameters on the Setup window can be set also in the Control Panel (page 30). This is convenient when you want to set the basic
parameters without having to start the MR Editor.
1
2
3
4
5
General Settings section
This section lets you set the basic parameters such as
Sample Rate and Word Clock. These parameter settings
are applied commonly to all the MR816 CSX/MR816 Xs
connected in daisy-chain fashion.
1 WORD CLOCK Master
2 Clock Source
3 Sample Rate
4 Buffer Size (Windows only)
These parameters are equivalent to those in the Control
Panel (page 30).
5 WDM Audio Routing IN/OUT (Windows only)
The IN section determines the input jack used for the
WDM Audio driver while the OUT section determines the
stereo output jack used for the WDM driver. In each sec-
tion, the upper box selects the device (only when two or
three MR816 CSX/MR816 Xs are daisy-chain connected)
and the lower box selects the input or output jacks.
NOTE
· This parameter specifies which jacks accept the input signals
sent to a computer and to which jacks the output signals from
the computer are sent. The input channels are stereo channels.
The output channels are six consecutive channels from the ste-
reo channels set in the output port setting.
· The port name (device name) of the WDM Audio driver is
"Yamaha Steinberg FW WDM Audio."
) at the left end of the main window. From
MR816 CSX Settings/MR816 X Settings sec-
tion
This section lets you set the parameters unique to the
connected device.
6 Digital I/O, External FX
7 Sweet Spot Morphing Ch. Strip (MR816 CSX
only)
8 External FX Type
These parameters are equivalent to those in the Control
Panel (page 30).
Note that the Effect Control section (page 38) is shown on
the Main window when the Digital I/O, External FX param-
eter ( 6 ) is set to "External FX."
9 Master Level meter
Turning this checkbox on will assign the level meter func-
tion for the master output to the LED lamps around the
Multi Function Encoder knob.
) Version
Indicates the firmware version of the MR816 CSX/
MR816 X.
MR Editor
6
7
8
)
9
41
Operation Manual