Steinberg MR816CSX Operation Manual page 36

MR Editor
VIEW section
This section lets you change the view format of the Mixer
section.
1 Analog icon
Click this to alternately display and hide the analog input
strips.
2 Digital icon
Click this to alternately display and hide the digital input
strips.
SETUP section
This section lets you call up the Setup window, Version
information window and Help window.
1 SETUP
Calls up the Setup window (page 41).
2 ABOUT
Calls up the Version information window.
3 HELP
Calls up the Operation Manual PDF (this manual).
36
1
2
1
2
3
Operation Manual
Input Mixer section
This section lets you adjust various mixing parameters
such as the volume, pan and effect send level of the audio
signal input via the analog/input jacks for each input
channel. The mixing parameters will be set for each out-
put channel which can be selected at the right end of the
main window.
1 Channel link
Click this to link the adjacent two channels to the one ste-
reo channel. Click this again to cancel the link. When this
link is set to on, all the parameters of L and R other than
pan (!) and phase (4) are linked.
2 Input jack icon
Indicates the Input jack corresponding to the input chan-
nel.
This type of icon corresponds to the
MIC/LINE/HI-Z jack on the front
panel, MIC/LINE jack on the front
MIC 1 – 8 panel and the MIC/LINE INPUT
jacks 3 – 8 on the rear panel. The
strip below this icon corresponds to
analog input channels 1 – 8.
This type of icon corresponds to the
ADAT (OPTICAL) IN jack on the rear
panel. The strip below this icon cor-
responds to the digital input chan-
ADAT 1 – 8 nel. The amount of channels differs
or S/PDIF depending on the digital audio for-
(optical) mat.
ADAT format:
Maximum mono input channel x 8
S/PDIF format:
Stereo input channel x 1
This type of icon corresponds to the
S/PDIF IN jack on the rear panel.
S/PDIF
The strip below this icon corre-
(coaxial)
sponds to the stereo digital input
channel.
1
2
3
5
4
6
9
8
7
)
!
@
#
$