Setting Up On The Computer - Steinberg MR816CSX Operation Manual

CAUTION
• To avoid damage to your hearing or speakers, be sure to roll
off the volume level of the amplifier (or powered speakers)
before turning the phantom power on or off. Steinberg/
Yamaha also recommends that you turn all output levels to
minimum settings before operating this button.
• Be sure to leave the phantom power off if you do not need it.
• When turning the phantom power on, make sure that only
condenser microphones are connected to the correspond-
ing input jacks. Devices other than condenser microphones
may be damaged if they are connected to the phantom
power supply. Note, however, that the phantom power may
be left on when you connect balanced dynamic micro-
phones.
• If you connect a device that requires an external power sup-
ply, first connect the device to an Input jack, then turn on the
phantom power. If you disconnect the device, make sure to
turn off the phantom power before disconnecting the device.
Using the MR816 CSX/MR816 X with Cubase

■ Setting up on the computer

Follow the steps below to set up your computer for using
the Link function with Cubase.
NOTE
· Before using the Cubase Link function, make sure to install
TOOLS for MR then make initial settings. For more information
about installation procedures and initial settings for the TOOLS
for MR, please refer to the Getting Started manual (printed
manual).
1
Start the computer.
Wait until the Word Clock Source lamps and Sample
Rate lamps finish flashing successively.
NOTE
· Note that the Clock Source lamps and Sampling Rate lamps
flash while Yamaha Steinberg FW Driver is performing setup of
the MR816 CSX/MR816 X. These lamps continue flashing if the
setup is not completed properly.
2
Start Cubase.
■ For Windows:
Click [Start] ➝ [All Program] ➝ [Steinberg Cubase 5] ➝
[Cubase 5] to start the program.
■ For Macintosh:
Double-click [Application] ➝ [Cubase 5] to start the pro-
gram.
If the following dialog appears while Cubase is starting,
click [OK].
3
When the "Cubase Open Document Options"
window appears, click [New Project].
The Project templates for the MR816 CSX/MR816 X
will be shown if the TOOLS for MR has already been
installed. Selecting any of these templates will auto-
matically set the routing of the audio input/output.
Project templates for the
MR816 CSX/MR816 X
11
Operation Manual