Steinberg MR816CSX Operation Manual page 17

NOTE
· For instructions on calling up the window when using Cubase
AI 4.5.1 or later, refer to page 21.
4
Perform the following operations as required.
● To adjust the effect depth:
Drag on the REV-X Send field below the REV icon
and move the pointer leftward or rightward to adjust
the send level.
● To adjust the effect parameters:
Click the REV-X Edit (
window. For information about the available param-
eters, refer to page 25.
● To adjust the effect type and return level:
Click the REV-X Setup to call up the MR816 CSX/
MR816 X Hardware Setup window. For information
about the available parameters, refer to page 23.
NOTE
· The MR816 CSX/MR816 X Hardware Setup window can be
called up also by selecting [Device] ➝ [Audio Hardware
Setup].
· Note that the REV-X effect cannot be used for the monitor sig-
nal when the MR816 CSX/MR816 X is set to the external effect
mode. In this case, the REV-X indication is not shown in the
MR816 CSX/MR816 X Input Settings window.
) to call up the REV-X Setup
Using the MR816 CSX/MR816 X with Cubase
Applying the Sweet Spot Morphing Channel
Strip to the monitor signals (MR816 CSX only)
The built-in Sweet Spot Morphing Channel Strip ("Channel
Strip" for short) can be applied to the audio signal which
is to be recorded or only to the monitor sound depending
on to which point this effect unit is inserted. For each input
channel of the MR816 CSX, if necessary, you can insert
the Channel Strip to the different location and adjust the
effect parameters on Cubase.
MR816 CSX input channels
Monitor
output
Channel Strip
Analog input 1
COMP EQ
Analog input 8
COMP EQ
Channel Strip
Digital input 1
COMP EQ
Digital input 8 COMP EQ
The instructions below apply to Cubase 4.5.1 or later.
1
Select [Devices] ➝ [Mixer] to call up the
Extended Mixer window.
If the Extended Mixer window is not shown, click the
arrow ( ) button ("Show Extended Mixer") to call it
up.
2
Call up the input channel mixer by clicking the
Input Channel indication icon (
the Mixer window.
3
Make sure that MR816 CSX/MR816 X Input Set-
tings window is shown on the Extended Mixer of
the Input Channel's mixer.
If the window is not shown, click the triangular (
button ("Extended View Type") then select "Hard-
ware" from the indicated menu.
Input bus Audio track
Input bus Audio track
Input bus Audio track
Input bus Audio track
Monitor
output
) at the left in
)
Channel Strip Edit
DRIVE
MORPH
Effect insertion setup
Extended View Type
Show Extended Mixer
Indication of the Input
Channel Mixer
17
Operation Manual