Steinberg MR816CSX Operation Manual page 38

MR Editor
# Solo
Turns solo on/off for each channel.
NOTE
· You can turn a specific input channel's solo on/off for all the out-
put channels simultaneously by clicking the solo (
the desired input channel while holding the [Alt] key or [option]
key on the computer keyboard. You can turn a specific input
channel's solo off for all the output channels simultaneously by
clicking the solo ( ) icon of the desired input channel while
holding the [Alt] key and [Ctrl] key simultaneously or holding
the [option] key and [command] key simultaneously.
$ Fader
Adjusts the volume level for each channel.
38
) icon of
Operation Manual
Effect Control section
When the MR816 CSX/MR816 X is set to External Effect
mode, clicking [EXT FX] at the Output section of the main
window will call up the dedicated effect window shown on
page 25, page 27. From that window, you can edit the
parameters of the effect unit inserted to an audio track of
the DAW software. This explanation covers the Effect Con-
trol section in that window.
NOTE
· For details on the External Effect mode, refer to page 19.
· To enable the External Effect mode, the "Digital I/O, External
FX" parameter should be set to "External FX" in the Setup win-
dow, page 41, or the Control Panel of the Yamaha FW Driver
window, page 30.
· While the MR816 CSX/MR816 X is set to External Effect mode,
you cannot use the internal effect for input signals other than
the input signal coming from the DAW software.
1
2 3
1 Channel Strip Edit
(MR816 CSX only)
Click this to call up the window for editing the parameters
of the Sweet Spot Morphing Channel Strip effect. Each of
the parameters on this window is equivalent to that of the
Channel Strip Edit (page 37) of the Input Mixer section.
2 DRIVE knob (MR816 CSX only)
Equivalent to the DRIVE knob (page 29) in the Sweet Spot
Morphing Channel Strip window.
3 MORPH knob (MR816 CSX only)
Equivalent to the MORPH knob (page 28) in the Sweet
Spot Morphing Channel Strip window.
4 REV-X Edit
Click this to call up the window for editing the parameters
of the REV-X effect. All of the parameters on this window
are the same as those of the window (page 25) called up
from Cubase with the exception of the file icon indicated
at the top of the window on the MR Editor. The file icon lets
you save or open the file.
File icon
5 Reverb type
Selects the reverb type from "Hall," "Room" and "Plate."
6 TIME (Reverb time)
Adjusts the reverb time.
5 4
6