Try Recording - Steinberg MR816CSX Operation Manual

Using the MR816 CSX/MR816 X with Cubase
NOTE
· For information about how to call up the above window when
using Cubase AI 4.5.1 or later, refer to page 21.
4
Perform the following operations as required.
● To set the insertion location of the effect unit:
Drag the slider for the effect insertion setup then
select the desired one from the following items.
When setting the
slider to the upper
position:
When setting the
slider to the middle
position:
When setting the
slider to the lower
position:
NOTE
· For details about the insertion location, refer to page 22.
● To adjust the effect parameters:
Click the Channel Strip Edit
nel Strip window. For information about the available
parameters, refer to page 27.
● To adjust the MORPH and DRIVE:
Drag the MORPH icon and DRIVE icon respectively
then move the pointer.
NOTE
· Note that the Channel Strip cannot be used for the monitor sig-
nal when the MR816 CSX/MR816 X is set to the external effect
mode. In this case, the Channel Strip is not shown in the
MR816 CSX/MR816 X Input Settings window.
18
The effect will be bypassed.
The effect will be applied only
to the monitor sound.
The effect will be applied to
both the monitor sound and
signals to be recorded.
to call up the Chan-
Operation Manual

■ Try recording

Now that you've completed the necessary settings, try
recording.
1
From the Transport window of Cubase, click the
"Record" button to start recording.
2
Play the instrument connected to the
MR816 CSX/MR816 X.
3
Click the "Stop" button after you've finished
playing.
4
Move the pointer to the beginning of the project
then click the "Start" button to hear the recorded
sound.