Steinberg MR816CSX Operation Manual page 40

MR Editor
Output section
This section lets you select the desired output for mixing.
Clicking one of the outputs (tabs) will call up the settings
for the selected output in the Input Mixer section. If the
MR816 CSX/MR816 X is set to the External Effect mode,
"EXT FX" tab will be shown in this section instead of the
digital output jacks.
In the Normal mode: In the External Effect mode:
1
2
1 OUT 1 – 2, OUT 3 – 4, OUT 5 – 6, OUT 7 – 8
These analog outputs correspond to the analog output
jacks (OUTPUT jacks 1&2, 3&4, 5&6 and 7&8 on the rear
panel).
2 ADAT, S/PDIF
These are available only when the current device (indi-
cated at the DEVICE column) is set to the Normal mode in
the Setup window. These digital outputs correspond to the
digital output jacks (S/PDIF jack or OPTICAL jack on the
rear panel). The number of digital output channels will dif-
fer depending on the setting as to which jack (S/PDIF or
OPTICAL) is used for digital input/output and (if the OPTI-
CAL OUT jack is used) which format (S/PDIF or ADAT) is
used. This setting can be performed in the Setup window
(page 41).
NOTE
· The headphone icon ( ) for each output channel indicates
whether or not you can hear the sound by using the head-
phones.
3 EXT FX
This is available only when the current device (indicated
at the DEVICE column) is set to the External Effect mode
(page 19) in the Setup window. Selecting this tab calls up
the Effect Control section containing the parameters for
the Sweet Spot Morphing Channel Strip effect
(MR816 CSX only) or REV-X effect, which has been
inserted a DAW software track by setting the MR816 CSX/
MR816 X to the External Effect mode. For information
about the External Effect mode, refer to page 19.
40
1
3
Operation Manual