Steinberg MR816CSX Operation Manual page 26

Dedicated windows for the MR816 CSX/MR816 X in Cubase
7 LPF (Low Pass Filter)
Determines the cutoff frequency of the low pass filter. The
low pass filter passes signals only below the specified
cutoff frequency.
Range: 1.0 kHz – 20.0 kHz
8 DIFFUSION
Determines the spread of the reverberation. The higher
the value, the greater the spread.
Range: 0 – 10
9 ROOM SIZE
Determines the size of the simulated room. The higher the
value, the greater the room size.
Range: 0 – 31
) HIGH RATIO
Determines the duration of reverberation in the high fre-
quency range by using a ratio relative to the REVERB
TIME parameter. When this parameter is set to 1, the
REVERB TIME setting is actually applied to the sound.
The lower the value, the shorter the duration of reverbera-
tion in the high frequency range.
Range: 0.1 – 1.0
! LOW RATIO
Determines the duration of reverberation in the low fre-
quency range by using a ratio relative to the REVERB
TIME parameter. When this parameter is set to 1, the
REVERB TIME setting is actually applied to the sound.
The lower the value, the shorter the duration of reverbera-
tion in the low frequency range.
Range: 0.1 – 1.4
@ DECAY
Determines the characteristic of the envelope from the
moment the reverberation starts to the moment it attenu-
ates and stops.
Range: 0 – 63
# MIX
This parameter determines the mix balance between the
reverberation produced by the REV-X and the original
input sound as expressed in a ratio. The higher the value,
the higher the ratio of reverberation to the original sound.
This parameter should be set to "100.0%" when the REV-X
is used as Send/Return while this parameter should be
adjusted when the REV-X is inserted to a specific channel.
You can view this parameter only by setting the "Digital I/O
External FX" parameter to "External FX" on the Control
Panel (page 30) or the MR Editor (page 41), using the
REV-X as a VST plug-in effect (page 19).
Range: 0.0% – 100.0%
26
Operation Manual