Steinberg MR816CSX Operation Manual page 12

Using the MR816 CSX/MR816 X with Cubase
4
Select the desired template then click [OK].
On the front panel of the MR816 CSX/MR816 X, the
[QUICK CONNECT] lamps to which audio tracks of
Cubase are assigned will light.
5
Select [Devices] ➝ [Device Setup...] to call up the
Device Setup window. Select "VST Audio Sys-
tem" in the Device column then confirm whether
or not "Yamaha Steinberg FW ASIO"/"Yamaha
Steinberg FW" is selected from the ASIO Driver
column.
If it is selected, click [OK] to close the window. The
MR816 CSX/MR816 X can now be linked to
Cubase.
Confirm "Yamaha Steinberg FW ASIO"/
"Yamaha Steinberg FW" is selected.
NOTE
· When changing the ASIO driver, a dialog box may appear ask-
ing "Do you want to switch the ASIO driver?". Click [Switch].
6
On the Device field, select "Yamaha Steinberg
FW ASIO" or "Yamaha Steinberg FW," make sure
that the checkbox of "Direct Monitoring" is
turned on, then click [OK] to close the window.
NOTE
· If the Direct Monitoring is turned on, you can monitor the
Cubase-mixed sound with no latency. Since the MR816 CSX/
MR816 X is equipped with the effect unit, you can monitor the
effect-applied signal even when the Direct Monitoring is turned
on. Furthermore, you can use the Direct Monitoring function in
the Studio Send also when you use the Control Room function.
It is recommended to turn the Direct Monitoring on to take a full
advantage of the linked functions between the MR816 CSX/
MR816 X and Cubase.
The settings on the computer have been completed.
12
Operation Manual
TIP
If you want to change the Sample Rate or routing of the
input/output bus, follow the instructions below.
● To change the Sample Rate:
Select [Project] ➝ [Project Setup] to call up the Project
Setup dialog.
After setting, click [OK] to close the dialog. According
to the setting made here, the Sample Rate of the
MR816 CSX/MR816 X will be changed automatically.
● To change the routing of the input/output bus:
Select [Devices] ➝ [VST Connections] to call up the
VST Connections window. From this window, you can
change the device port of the existing bus and add the
new bus.
Sample Rate of
the project file