Steinberg MR816CSX Operation Manual page 15

4
For each of the created Studios, assign "Yamaha
Steinberg FW ASIO" / "Yamaha Steinberg FW" to
the Audio Device and assign your desired output
jack to the Device Port.
After making the settings, close the VST Connec-
tions window by clicking [X] at the top right of the
window.
5
Select [Devices] ➝ [Control Room Mixer] to call
up the Control Room Mixer window.
6
Turn on the output of channels [1] – [4] by click-
ing each of them, then make sure that the input
of the corresponding channel is set to "AUX"
(instead of "MIX").
2. Turn the [AUX] on.
1. Turn on the Activate Channel buttons.
Using the MR816 CSX/MR816 X with Cubase
7
Select [Devices] ➝ [Mixer] to call up the
Extended Mixer window.
If the Extended Mixer window is not shown, click the
arrow ( ) button ("Show Extended Mixer") to call it
up.
8
Call up the Studio Send on the Extended Mixer
by clicking the "Show Studio Sends" button (
at the left on the window.
The Studio Send lets you create custom mixes for
the performer by specifying the level/pan/pre-fader/
post-fader settings. You can create mixes also by
using the fader/pan level of the main mix. In this
case, you may need to make certain adjustments.
For details, refer to the Cubase operation manual.
The Direct Monitoring function lets you hear the sig-
nal from the Input Channels of the MR816 CSX/
MR816 X without latency.
By performing the steps below, you can output the
mix created here via headphone jacks 1 and 2.
)
Studio Send
15
Operation Manual