Additional Information; Checking The System - Intergraph InterServe 9000 System Reference Manual

Additional Information

The RAID system boot drives are configured at the factory using Mylex RAID configuration
utilities. Additional disk drives supplied with the system are not configured. You must
configure these drives after configuring system software to make them usable to the system.
Refer to Chapter 3, "Configuring the System," for more information on configuring and
using the RAID disk arrays.
WARNING Do not turn on the system power until you are ready to configure Windows NT Server.
If you start the system, and then restart it before completely configuring the operating
system, you will have to reinstall system software as described in Chapter 5,
"Reinstalling System Software."

Checking the System

Before starting the deskside system, review the following items:
u
The cables are properly attached from the base unit to the various options and
peripherals.
u
All disk drives are installed in the proper slots and labeled appropriately.
u
The power cord from the system's AC receptacle is connected to the correct power
outlet.
Before starting the rack-mount system, review the following items:
u
All hardware is properly and securely installed in the rack.
u
The cables are properly attached from the base unit to the accessories installed in the
rack or in remote locations.
u
The cables attached to the server base unit are routed through the cable handler. Ensure
there is enough cable service loop to allow sliding devices to extend 31 inches.
u
The cables that run along the sides or top of the rack are installed in clips or ties to
secure them in place.
u
All disk drives are installed in the proper slots and labeled appropriately.
u
The base unit is retracted into the rack.
u
The power cord from the AC distribution box or UPS is attached to the correct power
outlet.
WARNING Once you install the equipment into the 40 U rack, do not move the rack. If you must
move it, first remove all equipment, move the rack to its new location, and then
reinstall the equipment.
21