Intergraph InterServe 9000 System Reference Manual page 60

50
8. Select Other and press
9. Insert the
10. When prompted, press
11. If a RAID controller is not installed, skip to the next step. If your system has a RAID
controller, do the following:
Select Other and press
Insert the
When prompted, press
12. Use the arrow key to scroll up, then select IDE CD-ROM (ATAPI 1.2)/PCI IDE
CONTROLLER and press
13. When prompted, insert 4
14. Accept the mass storage device configuration when displayed on the screen, and insert
the NT Server CD-ROM in the CD-ROM drive when prompted.
15. Follow the instructions on the screen to select or create a partition.
NOTE You must select an unformatted or FAT formatted partition. You cannot use an existing
NTFS partition. If you create a new partition, the maximum size is restricted to 4096 KB.
After you select a partition, you can select to have it formatted using NTFS file system.
16. At the "Insert the disk labeled Symbios Logic PCI (53c8xx)" prompt, insert the
diskette and press
17. At the "Insert the disk labeled Symbios Logic PCI High Performance Driver" prompt,
insert the
18. If your system has a RAID controller, you will be prompted to insert the diskette
containing the Mylex driver. Insert the
19. At the "Remove all diskettes and restart the system" prompt, insert 4
4 and press
20. At the DOS prompt, key in attrib -s -h -r c:\boot.ini.
21. At the DOS prompt, key in edit c:\boot.ini.
22. The
BOOT
[operating systems]
multi(0)disk(0)rdisk(0)partition(1)\WINNT="Windows NT Server
Version 4.00"
multi(0)disk(0)rdisk(0)partition(1)\WINNT="Windows NT Server
Version 4.00 [VGA mode]" /basevideo /sos
.
ENTER
diskette and press
SYMLVDSCSI
to specify additional devices.
S
ENTER
Disk 1 diskette and press
MYLEXPCIDRV
to specify additional devices.
S
ENTER
_
GB NTSSETUP
.
ENTER
diskette and press
SYMLVDSCSI
to restart the system.
ENTER
. file opens in edit mode. It will contain a section similar to the following:
INI
.
ENTER
.
ENTER
.
Disk 3 and press
.
ENTER
diskette and press
MYLEXPCIDRV
.
.
ENTER
.
ENTER
_
GB NTSSETUP
SYMSCSI
Disk