Installing The System Into A Rack - Intergraph InterServe 9000 System Reference Manual

14

Installing the System into a Rack

To install the system in the rack:
1. Pull the telescoping center bars out of the large outer bars until they are fully extended
and locked in place. See the following figure.
The faceplate appearance may vary from
that shown.
2. With two persons, carefully lift the system and gently slide the small bars attached to
each side of the chassis into the extended center bars.
3. When the system stops, press in on the safety latches on the small bars, and gently slide
the system into the rack.
4. Connect the cables as described next in "Connecting the Cables."
2
3
1
4
2
1 Small outer bar
2 Center bar
3 Large outer bar
4 Safety latch