Figure 40-1 Menu 24.11 Remote Management Control; Table 40-1 Menu 24.11 Remote Management Control - ZyXEL Communications Prestige 652H series User Manual

Prestige 652H/HW Series User's Guide
Enter 11, from menu 24, to display Menu 24.11 — Remote Management Control (shown next).
TELNET Server:
Server Port = 23
Secured Client IP = 0.0.0.0
FTP Server:
Server Port = 21
Secured Client IP = 0.0.0.0
Web Server:
Server Port = 80
Secured Client IP = 0.0.0.0
SNMP Service:
Server Port = 161
Secured Client IP = 0.0.0.0
The following table describes the fields in this menu.
FIELD
Telnet Server
FTP Server
Web Server
SNMP Service
Port
Access
Secured Client IP
Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to
Cancel" to save your configuration, or press [ESC] to cancel.
40-2
Menu 24.11 - Remote Management Control
Press ENTER to Confirm or ESC to Cancel:

Figure 40-1 Menu 24.11 Remote Management Control

Table 40-1 Menu 24.11 Remote Management Control

Each of these read-only labels denotes a service or protocol.
This field shows the port number for the service or protocol. You
may change the port number if needed, but you must use the same
port number to access the Prestige.
Select the access interface (if any) by pressing the [SPACE BAR].
Choices are: LAN only, WAN only, All or Disable. The default is
LAN only.
The default 0.0.0.0 allows any client to use this service or protocol
to access the Prestige. Enter an IP address to restrict access to a
client with a matching IP address.
Server Access = LAN only
Server Access = LAN only
Server Access = LAN only
Server Access = ALL
DESCRIPTION EXAMPLE
23
LAN only
0.0.0.0
Remote Management