Telnet; Figure 212 Menu 24.11 - Remote Management Control; Table 125 Menu 24.11 - Remote Management Control - ZyXEL Communications ZyAIR G-2000 PLUS User Manual

ZyAIR G-2000 Plus User's Guide
Figure 212 Menu 24.11 – Remote Management Control
TELNET Server:
FTP Server:
Web Server:
SNMP Service:
DNS Service:
The following table describes the fields in this screen.
Table 125 Menu 24.11 – Remote Management Control
FIELD
Telnet Server
FTP Server
Web Server
SNMP Service
DNS Service
Port
Access
Secure Client IP The default 0.0.0.0 allows any client to use this service or protocol to access the
Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to
Cancel" to save your configuration, or press [ESC] to cancel.

36.1.1 Telnet

You can configure your ZyAIR for remote Telnet access as shown next.
369
Menu 24.11 - Remote Management Control
Port = 23
Secure Client IP = 0.0.0.0
Port = 21
Secure Client IP = 0.0.0.0
Port = 80
Secure Client IP = 0.0.0.0
Port = 161
Secure Client IP = 0.0.0.0
Port = 53
Secure Client IP = 0.0.0.0
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
Each of these read-only labels denotes a service or protocol.
This field shows the port number for the service or protocol. You may change the
port number if needed, but you must use the same port number to access the
ZyAIR.
Select the access interface (if any) by pressing [SPACE BAR], then [ENTER] to
choose from: LAN only, WAN only, ALL or Disable.
ZyAIR. Enter an IP address to restrict access to a client with a matching IP address.
Access = LAN only
Access = LAN only
Access = LAN only
Access = LAN only
Access = LAN only
Chapter 36 Remote Management