Table 44-1 Menu 27.2 Sa Monitor - ZyXEL Communications Prestige 652H series User Manual

Prestige 652H/HW Series User's Guide
FIELD
# This is the security association index number.
Name This field displays the identification name for this VPN policy. This name is
unique for each connection where the secure gateway IP address is a public
static IP address.
When the secure gateway IP address is 0.0.0.0 (as discussed in the last
chapter), there may be different connections using this same VPN rule. In this
case, the name is followed by the remote IP address as configured in Menu
27.1.1. – IPSec Setup. Individual connections using the same VPN rule may
be terminated without affecting other connections using the same rule.
Encap. This field displays Tunnel mode or Transport mode. See previous for
discussion.
IPSec This field displays the security protocols used for an SA. ESP provides
ALgorithm confidentiality and integrity of data by encrypting the data and encapsulating it
into IP packets. Encryption methods include 56-bit DES and 168-bit 3DES.
NULL denotes a tunnel without encryption.
An incoming SA may have an AH in addition to ESP. The Authentication
Header provides strong integrity and authentication by adding authentication
information to IP packets. This authentication information is calculated using
header and payload data in the IP packet. This provides an additional level of
security. AH choices are MD5 (default - 128 bits) and SHA -1(160 bits).
Both AH and ESP increase Prestige processing requirements and
communications latency (delay).
Select Press [SPACE BAR] to choose from Refresh, Disconnect, None, Next Page,
Command or Previous Page and then press [ENTER]. You must select a connection in
the next field when you choose the Disconnect command. Refresh displays
current active VPN connections. None allows you to jump to the "Press
ENTER to Confirm..." prompt.
Select Next Page or Previous Page to view the next or previous page of rules
(respectively).
Select Type the VPN connection index number that you want to disconnect and then
Connection press [ENTER].
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to Confirm..." to save
your configuration, or press [ESC] at any time to cancel.
44-2

Table 44-1 Menu 27.2 SA Monitor

DESCRIPTION EXAMPLE
Taiwan
Tunnel
ESP DES
MD5
Refresh
1
SA Monitor