Figure 34-12 Menu 21.1.6.1 Sample Filter - ZyXEL Communications Prestige 652H series User Manual

Prestige 652H/HW Series User's Guide
Step 4. Press [ENTER] at the message
21.1.6 — Filter Rules Summary.
Step 5. Type 1 to configure the first filter rule. Make the entries in this menu as shown next.
When you press [ENTER] to confirm, the following screen appears. Note that there is only one filter rule in
this set.
Filter #: 6,1
Filter Type= TCP/IP Filter Rule
Active= Yes
IP Protocol= 6
Destination: IP Addr= 0.0.0.0
Source: IP Addr= 0.0.0.0
TCP Estab= No
More= No
Action Matched= Drop
Action Not Matched= Forward
There are no
more rules to
check.
Select Drop here so that the
packet will be dropped if its
destination is the telnet port.
34-16
"
Menu 21.1.6.1 - TCP/IP Filter Rule
IP Source Route= No
IP Mask= 0.0.0.0
Port #= 23
Port # Comp= Equal
IP Mask= 0.0.0.0
Port #=
Port # Comp= Equal
Log= None
Press ENTER to Confirm or ESC to Cancel:

Figure 34-12 Menu 21.1.6.1 Sample Filter

Press [ENTER] to confirm or [ESC] to cancel" to open Menu
Select Equal here
as we are looking
for packets going
to port 23 only.
Select Forward here so that the packet will be forwarded if
its destination is not the telnet port and there are no more
rules in this filter set to check. Select Next if there are
more rules to check.
Press [SPACE BAR] to choose this
filter rule type. The first filter rule
type determines all subsequent filter
types within a set.
Select Yes to make the rule active.
6 is the TCP protocol.
The port number for the telnet
service (TCP protocol) is 23. See
RFC-1060 for port numbers of well-
known services.
Filter Configuration