Figure 30-4 Menu12.1.1 Edit Ip Static Route; Table 30-1 Menu12.1.1 Edit Ip Static Route - ZyXEL Communications Prestige 652H series User Manual

The following table describes the fields for Menu 12.1.1 – Edit IP Static Route.
FIELD
Route # This is the index number of the static route that you chose in menu 12.1.
Route Name Type a descriptive name for this route. This is for identification purpose only.
Active This field allows you to activate/deactivate this static route.
Destination IP This parameter specifies the IP network address of the final destination. Routing is
Address always based on network number. If you need to specify a route to a single host, use a
subnet mask of 255.255.255.255 in the subnet mask field to force the network number
to be identical to the host ID.
IP Subnet Mask Type the subnet mask for this destination. Follow the discussion on IP Subnet Mask in
this manual.
Gateway IP Type the IP address of the gateway. The gateway is an immediate neighbor of your
Address Prestige that will forward the packet to the destination. On the LAN, the gateway must
be a router on the same segment as your Prestige; over WAN, the gateway must be
the IP address of one of the remote nodes.
Metric Metric represents the "cost" of transmission for routing purposes. IP routing uses hop
count as the measurement of cost, with a minimum of 1 for directly connected
networks. Type a number that approximates the cost for this link. The number need not
be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually a good
number.
Static Route Setup
Menu 12.1.1 - Edit IP Static Route
Route #: 1
Route Name= ?
Active= No
Destination IP Address= ?
IP Subnet Mask= ?
Gateway IP Address= ?
Metric= 2
Private= No
Press ENTER to Confirm or ESC to Cancel:

Figure 30-4 Menu12.1.1 Edit IP Static Route

Table 30-1 Menu12.1.1 Edit IP Static Route

Prestige 652 Series User's Guide
DESCRIPTION
30-3