ZyXEL Communications Prestige 652H series User Manual page 216

Prestige 652H/HW Series User's Guide
LABEL
Local
Local Address Type
IP Address Start
End / Subnet Mask
Remote
Remote Address
Type
16-12
Table 16-7 VPN IKE
Local IP addresses must be static and correspond to the remote IPSec router's
configured remote IP addresses.
Two active SAs can have the same configured local or remote IP address, but not
both. You can configure multiple SAs between the same local and remote IP
addresses, as long as only one is active at any time.
In order to have more than one active rule with the Secure Gateway Address field
set to 0.0.0.0, the ranges of the local IP addresses cannot overlap between rules.
If you configure an active rule with 0.0.0.0 in the Secure Gateway Address field
and the LAN's full IP address range as the local IP address, then you cannot
configure any other active rules with the Secure Gateway Address field set to
0.0.0.0.
Use the drop-down menu to choose Single, Range, or Subnet. Select Single for a
single IP address. Select Range for a specific range of IP addresses. Select
Subnet to specify IP addresses on a network by their subnet mask.
When the Local Address Type field is configured to Single, enter a (static) IP
address on the LAN behind your Prestige. When the Local Address Type field is
configured to Range, enter the beginning (static) IP address, in a range of
computers on your LAN behind your Prestige. When the Local Address Type field
is configured to Subnet, this is a (static) IP address on the LAN behind your
Prestige.
When the Local Address Type field is configured to Single, this field is N/A.
When the Local Address Type field is configured to Range, enter the end (static)
IP address, in a range of computers on the LAN behind your Prestige. When the
Local Address Type field is configured to Subnet, this is a subnet mask on the
LAN behind your Prestige.
Remote IP addresses must be static and correspond to the remote IPSec router's
configured local IP addresses. The remote fields do not apply when the Secure
Gateway IP Address field is configured to 0.0.0.0. In this case only the remote
IPSec router can initiate the VPN.
Two active SAs cannot have the local and remote IP address(es) both the same.
Two active SAs can have the same local or remote IP address, but not both. You
can configure multiple SAs between the same local and remote IP addresses, as
long as only one is active at any time.
Use the drop-down menu to choose Single, Range, or Subnet. Select Single with
a single IP address. Select Range for a specific range of IP addresses. Select
Subnet to specify IP addresses on a network by their subnet mask.
DESCRIPTION
VPN Screens