ZyXEL Communications Prestige 652H series User Manual page 342

Prestige 652H/HW Series User's Guide
FIELD
Sustain Cell Sustained Cell Rate is the mean cell rate of a bursty, on-off traffic
Rate (SCR)= 0 source that can be sent at the peak rate, and a parameter for burst-
traffic. Type the SCR; it must be less than the PCR.
Maximum Burst Refers to the maximum number of cells that can be sent at the peak
Size (MBS) rate. Type the MBS. The MBS must be less than 65535.
My Login Configure the My Login and My Password fields for PPPoA and
PPPoE encapsulation only. Enter the login name that your ISP gives
you. If you are using PPPoE encapsulation, then this field must be of
the form
name.
My Password Enter the password associated with the login name above.
ENET ENCAP Enter the gateway IP address supplied by your ISP when you are
Gateway using ENET ENCAP encapsulation.
Idle Timeout This value specifies the number of idle seconds that elapse before the
Prestige automatically disconnects the PPPoE session.
IP Address
Press [
Assignment
assignment.
IP Address Enter the IP address supplied by your ISP if applicable.
Network
Press [
Address
Please see the NAT Chapter for more details on the SUA (Single User
Translation
Account) feature.
Address Type the numbers of mapping sets (1-8) to use with NAT. See the
Mapping Set NAT chapter for details.
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to confirm or ESC to
cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.
If all your settings are correct your Prestige should connect automatically to the Internet. If the connection
fails, note the error message that you receive on the screen and take the appropriate troubleshooting steps.
27-6
Table 27-2 Menu 4 Internet Access Setup
DESCRIPTION
user@domain where domain identifies your PPPoE service
SPACE BAR
] to select Static or Dynamic address
SPACE BAR
] to select None, SUA Only or Full Feature.
EXAMPLE
0
0
N/A
N/A
N/A
0
Dynamic
N/A
SUA Only
N/A
Internet Access