ZyXEL Communications Prestige 652H series User Manual page 126

Prestige 652H/HW Series User's Guide
LABEL
AT Response
Strings
CLID
Called ID
Speed
Call Control
Dial Timeout
Retry Count
Retry Interval
Drop Timeout
Call Back Delay
Back
OK
Cancel
8-18
Table 8-4 Advanced Modem Setup
Type the keyword that precedes the CLID (Calling Line Identification) in the AT
response string. This lets the Prestige capture the CLID in the AT response string that
comes from the WAN device. CLID is required for CLID authentication. Example:
NMBR
Type the keyword preceding the dialed number.
Type the keyword preceding the connection speed. Example: CONNECT
Type a number of seconds for the Prestige to try to set up an outgoing call before
timing out (stopping). Example: 60
Type a number of times for the Prestige to retry a busy or no-answer phone number
before blacklisting the number. Example: 0
Type a number of seconds for the Prestige to wait before trying another call after a call
has failed. This applies before a phone number is blacklisted. Example: 10
Type the number of seconds for the Prestige to wait before dropping the DTR signal if
it does not receive a positive disconnect confirmation. Example: 20
Type a number of seconds for the Prestige to wait between dropping a callback
request call and dialing the corresponding callback call. Example: 15
Click Back to return to the previous screen.
Click OK to return to the previous screen, then click OK to return to the next previous
screen and click Apply to save the changes.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
WAN Setup