Telnet; Figure 203 Menu 24.11 - Remote Management Control; Table 126 - ZyXEL Communications ZyAir G-2000 PlusV2 User Manual

ZyXEL G-2000 Plus v2 User's Guide
Figure 203 Menu 24.11 – Remote Management Control
TELNET Server:
FTP Server:
Web Server:
SNMP Service:
DNS Service:
The following table describes the fields in this screen.

Table 126

FIELD
Telnet Server
FTP Server
Web Server
SNMP Service
DNS Service
Port
Access
Secure Client IP
Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to
Cancel" to save your configuration, or press [ESC] to cancel.

35.1.1 Telnet

You can configure your ZyXEL device for remote Telnet access as shown next.
356
Menu 24.11 - Remote Management Control
Port = 23
Secure Client IP = 0.0.0.0
Port = 21
Secure Client IP = 0.0.0.0
Port = 80
Secure Client IP = 0.0.0.0
Port = 161
Secure Client IP = 0.0.0.0
Port = 53
Secure Client IP = 0.0.0.0
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
Each of these read-only labels denotes a service or protocol.
This field shows the port number for the service or protocol. You may change the
port number if needed, but you must use the same port number to access the
ZyXEL device.
Select the access interface (if any) by pressing [SPACE BAR], then [ENTER] to
choose from: LAN only, WAN only, ALL or Disable.
The default 0.0.0.0 allows any client to use this service or protocol to access the
ZyXEL device. Enter an IP address to restrict access to a client with a matching IP
address.
Access = LAN only
Access = LAN only
Access = LAN only
Access = LAN only
Access = LAN only
Chapter 35 Remote Management