Table of Contents
Advertisement
(2) Condensation custom edit
Condensation custom edit screen
1) Press
to display the reverse feed stitching setting screen.
2) Press 2 or 4
in the reverse feed stitching setting screen to move to the condensation custom edit screen.
3) Set the needle entry position for each step in the condensation custom edit screen.
1 : Set the step with "+" and "–" key.
2 : Set the value of needle entry point from the center of zigzag with "+" and "–". "+" value comes on
the right side and "–" value on the left side.
3 : Needle entry position is displayed.
4 : Insert needle entry point 0. 0 for one stitch to the existing step. Then the stitches move backward
one stitch by one stitch.
* It is not possible to insert it when the number of total stitches is 64 stitches.
5 : Delete one stitch of the needle entry of the existing step. Then the stitches move forward one stitch by
one stitch.
* It is not possible to delete it when the number of total stitches is "1" stitch.
7 : Set the feed amount with "+" and "–".
Example of condensation custom creation
Example) Condensation custom at sewing start Width 4 mm for standard zigzag stitch
Needle
1th
entry
stitch
Input
– 2.0
value
Feed
amount
1 Input the data in the list above to each step.
Reverse feed stitching setting screen
2 Set to 4 mm at 1.
When 1 is changed, the inputted needle entry can be enlarged/reduced.
4) When setting up to the last step is completed, proceed to the next step, press
* When the last step is 64, it is not necessary to set "END" mark
84
1 2
1 2
7
4
2th
3th
4th
stitch
stitch
stitch
– 0.7
0.6
0.1
0.1
0.1
1
3
6
5
5th
6th
7th
stitch
stitch
stitch
2.0
0.6
– 0.7
–2.0
0.1
0.1
0.1
8th
9th
10th
stitch
stitch
stitch
– 0.7
0.6
0.1
0.1
0.1
6 and put END mark
.
11th
stitch
2.0
END
0.1
.
Advertisement
Table of Contents
