Table of Contents
Advertisement
9 Holding time of lifting presser foot (Function setting No.47 T-FL)
Solenoid type presser foot lifter (No. 46 0) can adjust the holding time control of lifting presser foot.
This function automatically lowers the presser foot when the time set with the setting No. 47 has passed
after lifting the presser foot.
When the pneumatic type presser foot lifter (No. 46 1) is selected, the holding time control of lifting presser
foot is limitless regradless of the set value.
Setting range
10 to 600 sec <10 / sec>
!0 Foot lift function after thread trimming (Function setting No.55 FLAT)
This function can automatically lift the presser foot after thread trimming. This function is effective only
when it is used in combination with the AK device.
0 : off
1 : on
!1 Reverse revolution to lift the needle after thread trimming (Function setting No.56 RATRM)
This function is used to make the sewing machine rotate in the reverse direction after thread trimming to lift
the needle bar almost to highest position. Use this function when the needle appears under the presser foot
and it is likely to make scratches on the sewing products of heavy-weight material or the like.
0 : off
1 : on
The needle bar is raised, by rotating the machine in the reverse direction, almost to the
Cau tion
highest dead point. This may result in slip-off of the needle thread. It is therefore necessary
to adjust the length of thread remaining after thread trimming properly.
When the function of reverse revolution to lift the needle after thread trimming is set, the
needle bar is out of the UP position after thread trimming. It is necessary to turn the
handwheel by hand when turning ON the power next time. It is not possible to enter the
edit screen at the time of reverse revolution to lift the needle after thread trimming. It is
Reference
necessary to adjust the position to UP position by turning the handwheel by hand before
entering the edit screen.
!2 Function of holding predetermined upper / lower position of the needle bar (Function setting No.58
HPOS)
When the needle bar is in the upper position or in the lower position, this function holds the needle bar by
applying a brake slightly.
0 : off
1 : on
!3 Change-over function of AUTO/Pedal for sewing speed of the reverse feed stitching at the start of
sewing (Function setting No.59 SBTO)
This function selects whether the reverse feed stitching at the start of sewing is performed without a break at
the speed set by the function setting No. 8 or the stitching is performed at the speed by the pedal operation.
0 : Manu The speed is indicated by the pedal operation.
1 : Auto
1. The max. sewing speed of the reverse feed stitching at the start of sewing is limited to
Cau tion
the speed set by the function setting No. 8 regardless of the pedal.
2. When "0" is selected, stitches of reverse feed stitching may not match those of normal
feed stitching.
Function of automatically lifting the presser foot is not provided.
(Presser foot does not automatically go up after thread trimming.)
Function of automatically lifting the presser foot is provided.
(Presser foot automatically goes up after thread trimming.
Function of making the sewing machine rotate in the reverse direction to lift the needle
after thread trimming is not provided.
Function of making the sewing machine rotate in the reverse direction to lift the needle
after thread trimming is provided.
Function of holding predetermined upper/lower position of the needle bar is ineffective.
Function of holding predetermined upper/lower position of the needle bar is effective.
Automatic stitching at the specified speed
117
Advertisement
Table of Contents
