Table of Contents
Advertisement
7 Teaching switch
8 Information switch
9 Feed amount display switch
!0 One-shot stitching switch
!1 With/without automatic
thread trimmer switch
!2 Thread trimming
prohibiting switch
!3 Counter value setting
switch
!4 Max. speed limitation variable
resistor
!5 Power display lamp
!6 Smart media cover
!7 Smart media slot
(Smart media inserting opening)
This is the switch to set the setting of the number of stitches with
the value of number of stitches which has been actually sewn.
This is the switch to perform various function settings.
Number of rotations, normal feed amount and reverse feed amount
of the pattern which is selected at present are displayed.
1
2
3
When this switch is set to effective at the time of program stitching,
the sewing machine automatically operates up to the specified
number of stitches.
When this switch is set to effective at the time of program stitching,
the sewing machine automatically performs thread trimming when
the specified number of stitches has been completed.
This switch prohibits all thread trimmings.
* This switch cannot be used with the sewing machine which is not
provided with the automatic thread trimming device.
This is the switch to set the value of bobbin thread counter or No. of
pcs. counter.
When moving the resistor in the left direction, max. speed is limited.
This lamp lights up when the power switch is turned ON.
This is the cover for smart media inserting opening.
To open the cover, place your finger on the notch located on the
side of the cover as shown in the figure and push the cover in the
direction of left slanting rear.
* The respective functions of the operation panel do not work with
the cover opened.
Do not close the cover unless smart media is completely inserted.
For the details, see p. 104.
To set smart media, insert smart media into smart media slot and
push it until it is almost hidden.
To remove smart media, push it further again and it protrudes to the
position where it can be held between your fingers. Now, draw it out.
* Be very careful of the inserting direction of smart media.
For the details, see p. 104.
1 : Number of rotations
2 : Reverse feed amount
3 : Normal feed amount
* The above amounts are not displayed
at the time of cycle stitching.
23
Advertisement
Table of Contents
