Removing And Replacing Components; Safety Information; Service Tools Required; Accessing A Rack Mounted Server - HP Integrity rx1600 Operation And Maintenance Manual

7

Removing and Replacing Components

This chapter provides instructions for removing and replacing components of the hp Integrity rx1600 Server.

Safety Information

Follow the procedures listed below to ensure safe handling of components and to prevent harm to both you and the HP Server:
• Use an antistatic wrist strap and a grounding mat, such as those included in the Electrically Conductive Field Service
Grounding Kit (P/N 9300-1155).
• Handle accessory boards and components by the edges only. Do not touch any metal-edge connectors or any electrical
components on accessory boards.
• Do not wear clothing subject to static charge build-up, such as wool or synthetic materials.
WARNING Hazardous voltages are present inside the HP Server. Always remove AC power from the server
and associated assemblies while working inside the unit. Serious injury may result if this warning is
not observed.

Service Tools Required

Service of this product may require one or more of the following tools:
• IPF CPU Install Tool Kit (P/N 5069-5441), consisting of:
• Disposable ESD Kit
• Label-less CPU install tool (2.5mm hex and Torx 15)
• 1/4 inch Flat Blade Screwdriver
• Phillips No. 1 Screwdriver
• ACX-10 Torx Screwdriver
• ACX-15 Torx Screwdriver
• ACX-25 Torx Screwdriver

Accessing a Rack Mounted Server

The hp Integrity rx1600 Server is designed to be rack mounted. The following procedure explains how to gain access to an hp
Integrity rx1600 Server that is mounted in an approved rack.
Chapter 7
131